Polaris 2013 RANGER RZR S - Page 343

8.19
TRANSMISSION
8
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
17. Install the reverse clutch assembly onto the park
flange. Note the orientation of the needle bearing.
18. Install the retaining plate and a new retaining ring.
19. Install the input shaft seal and verify it is fully seated.
Install th
e intermediate shaft seal (circled) flush or
slightly below the case. Apply lubricant to both seal
lips.
20. Place the transmission shift housing onto a flat
su
rface as shown. Apply a bead of crankcase sealant
onto the mating surfaces. Align the dowels and install
the transmission case half onto the shift housing while
rotating the input shaft, using care not to damage the
seal surfaces.
21. Install the shift cable bracket and (7) shift housing
c
ase screws to the front of the transmission. Torque
to specification.
Apply Sealant: PN 2871557
to Case Mating Surfaces
= T
Shift Housing Screws:
23-27 ft-lbs (31-37 Nm)
2871557
PRELIMINARY VERSION