Polaris 2013 RANGER RZR S - Page 99

3.47
ENGINE / COOLING
3
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
34. Press shaft into the new bearing.
35. Press the bearing/shaft assembly using the bearing's
o
uter race. Do not use the shaft to press the assembly
into the housing, as bearing damage may result.
Install retaining ring.
36. Press gear onto shaft while supporting the housing.
37. Remove thrust plate (U).
38. Remove PTO end engine mount. Remove crankcase
b
olts. Tap on the reinforced areas on the cases using
soft hammer. Carefully separate the two crankcase
halves.
NOTE: Only remove the oil baffle if the baffl
e is
damaged. When removing the oil baffle bolts, use a
heat gun to heat the bolts and loosen the Loctite
.
This will prevent any possible damage to the bolts or
to the crankcase casting.
Press On Bearing
Press Bearing / Shaft
Assembly using
outer race only
U
Separate
Crankcase Halves
PRELIMINARY VERSION