To Next Page

To Previous Page

6.5

9925723 R01 - 2015 RZR 900 Service Manual

Shift Cable Inspection

Shift cable adjustment may be necessary if symptoms

include:

• No gear position or AWD display on instrument

cluster

• Ratcheting noise on deceleration

• Inability to engage into a gear

• Excessive gear lash (noise)

• Gear selector moving out of desired range

Inspect shift cable, clevis pins, and pivot bushings and

replace if worn or damaged.

Shift Cable Adjustment

1. Locate the shift cable attached to the transmission

case in the right rear wheel well area.

2. Inspect shift cable

, clevis pin, pivot bushings, and

dust boot

. Replace if worn or damaged.

3. If adjustment is required, loosen the lower jam nut

and pull the cable out of the mount

to move the

upper jam nut

4. Adjust the shift cable so there is the same amount of

cable travel when shifting slightly past HIGH gear and

PARK.

5. Thread the upper or lower jam nut as required to

obtain proper cable adjustment.

NOTE: This procedure may require a few

attempts to obtain the proper adjustment.

6. Once the proper adjustment is obtained, place the

shift cable and upper jam nut into the mount. Tighten

the lower jam nut against the mount.

7. Start engine and shift through all gears to ensure the

shift cable is properly adjusted. If transmission still

ratchets after cable adjustment, the transmission will

require service.

TRANSMISSION

Polaris 2015 RZR 900 Service Manual

Other manuals for Polaris 2015 RZR 900