Polaris 2015 RZR 900 Service Manual

3.20
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
ENGINE SERVICE
Lubrication Specifications
Oil Capacity* ≈ 2.5 Quarts (2.4 L)
Oil Filter Wrench PU-50105 or 2.5″ (64
mm)
Oil Filter 2540086
Oil Type
Ambient Temp Range:
-35° F to 100° F
PS-4 Synthetic Engine Oil
2876244 – Qt
Oil Type
Ambient Temp Range:
0° F to 120° F
PS-4 Extreme Duty
Synthetic Engine Oil
2878920 – Qt
Oil Pressure (idle)
at 70° F: 72 PSI
at 220° F: 60 PSI
* Additional oil may be required after complete engine
disassembly. Check level after filling and add oil as
needed.
Engine Oil Pressure Test
1. Attach the Oil Pressure Gauge Adapter (PU-50565)
to the Oil Pressure Gauge (PV-43531).
Oil Pressure Gauge: PV-43531
Oil Pressure Gauge Adapter: PU-50565
2. Clean the area around the main oil gallery plug
1
,
located in the upper crankcase on the MAG side of
the engine.
3. Remove the plug and insert the oil pressure adapter.
4. Start engine and allow it to reach operating
temperature. Monitor the gauge.
NOTE: Test results are based on the use of the
recommended engine oil (Polaris PS-4 or PS-4
Extreme Duty) at operating temperature, and may
vary considerably if any other oil is used or if the
engine is not up to operating temperature.
Oil Pressure (engine at operating temp)
Standard @ 1200 RPM: 60 PSI
Minimum: 15 PSI
5. Upon assembly, torque the crankcase gallery plug to
specification.
Crankcase Gallery Plug:
11 ft-lb (15 Nm)
ENGINE / COOLING SYSTEM

Polaris 2015 RZR 900 Specifications

General

Brand	Polaris
Model	2015 RZR 900
Category	Utility Vehicle
Language	English