To Next Page

To Previous Page

11.19

9925723 R01 - 2015 RZR 900 Service Manual

BATTERY

Battery Specifications

Battery Removal

1. Remove the driver’s seat to access the battery

2. Disconnect the black (negative) battery cable.

CAUTION

To reduce the chance of sparks: Whenever removing

the battery, disconnect the black (negative) cable first.

When reinstalling the battery, install the black (negative)

cable last.

3. Disconnect the red (positive) battery cable.

4. Remove the battery hold-down bracket

5. Lift the battery out of the vehicle.

Battery Installation

NOTE: Using a new battery that has not been fully

charged can damage the battery and result in a

shorter life. It can also hinder vehicle performance.

Refer to Battery Charging, page 2.29 before

installing the battery.

1. Ensure the battery is fully charged.

2. Place the battery in the battery holder and secure

with hold-down bracket. Torque bracket fastener to

specification.

Battery Hold-Down Bracket:

8 ft-lb (11 Nm)

3. Coat the terminals with dielectric grease or petroleum

jelly.

4. Connect and tighten the red (positive) cable (s) first.

Torque fasteners to specification.

Battery Terminal Fasteners:

60 in-lb (7 Nm)

5. Connect and tighten the black (negative) cable (s)

last.

6. Verify that cables are properly routed and reinstall the

driver’s seat.

ELECTRICAL

Polaris 2015 RZR 900 Service Manual

Other manuals for Polaris 2015 RZR 900