Polaris 2015 RZR 900 Service Manual

2.36
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
2. Loosen the upper jam nut adjustment ring using the
spanner wrench (PN 2877408) included in the
vehicle’s tool kit.
Shock Spanner Wrench:
PN 2877408
3. Turn the lower adjustment ring
1
clockwise to
increase ride height or counter-clockwise to decrease
ride height.
IMPORTANT: DO NOT increase the spring
adjustment by more than one inch (25.4 mm) over
the factory setting.
4. Once you have obtained the correct ride height, hold
the lower adjustment ring while tightening the upper
adjustment ring to lock them in place.
IMPORTANT: Always return the spring to the
factory setting
2
after the load is removed from
the vehicle. The increased suspension height will
negatively impact vehicle stability when
operating without a load.
Shock Compression Adjustment (FOX)
The compression damping adjustment is located on top
of the shock ‘Piggyback’ reservoir of each shock.
Turn the clicker adjuster knob to make damping
adjustments.
NOTE: When clicker adjuster is turned clockwise
until it stops, damping is in the fully closed position.
Turn the clicker clockwise to increase compression
damping. Turn the clicker counter-clockwise to decrease
compression damping.
NOTE: The factory setting is 12 clicks from closed.
Refer to the “Compression Adjustment Table”.
Compression Adjustment Table
SETTING COMPRESSION DAMPING
Softest
Full counter-clockwise position
FACTORY 12 clicks from closed
Firmest 2 clicks from closed
MAINTENANCE

Polaris 2015 RZR 900 Specifications

General

Brand	Polaris
Model	2015 RZR 900
Category	Utility Vehicle
Language	English