Polaris 2015 RZR 900 Service Manual

8.22
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
Rear Stabilizer Bar Replacement
NOTE: Although the rear stabilizer bar mounting
varies by model, the replacement procedure is the
same.
1. Lift and support the rear of the vehicle by the frame.
2. Remove the fasteners retaining the stabilizer bar
1
to
the linkage
2
on both sides of the vehicle.
3. Remove the fasteners
3
retaining the stabilizer bar
brackets
4
to the vehicle frame and remove the
brackets/bushings.
4. Remove the stabilizer bar from the vehicle.
5. To Install, carefully install the stabilizer bar in the
vehicle.
6. Fully install the stabilizer bar, bushings, bracket and
fasteners. Center stabilizer bar in the frame. Torque
mounting fasteners to specification.
Stabilizer Bar Mounting Bolts:
16 ft-lb (22 Nm)
7. Install the stabilizer bar linkage fasteners. Torque
fasteners to specification.
Stabilizer Bar Linkage Fasteners:
40 ft-lbs (54 Nm)
8. Lubricate the stabilizer bar bushings. See
Maintenance chapter – Grease Lubrication Points,
page 2.8
STEERING / SUSPENSION

Polaris 2015 RZR 900 Specifications

General

Brand	Polaris
Model	2015 RZR 900
Category	Utility Vehicle
Language	English