Polaris RZR XP Turbo User Manual

2.38
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
8. Elevate the front of the vehicle at approx. 2 feet (60
cm)
e
.
9. Safely secure the vehicle.
10.Slowly fill the cooling system at the coolant reservoir
with 50/50 extended life coolant. Refer to Chapter 1 –
General Specifications for approximate coolant
system capacity.
NOTE
Elevating the unit will help reduce any air pockets in the
system when filling with coolant.
11. Fill the reservoir to the FULL COLD line.
12.Proceed to bleed the cooling system. See Cooling
System Bleeding, page 2.38.
COOLING SYSTEM BLEEDING
ENGINE COOLING SYSTEM BLEEDING
1. Remove the hood panel.
2. Remove the coolant pressure cap
q
. Fill coolant to
the FULL COLD line
w
on the coolant tank.
3. Elevate the front of the vehicle at approx. 2 feet (60
cm)
e
.
4. Remove the cargo box engine access panel.
5. Place a drain pan below the engine to catch any
coolant out of the engine bleed hole.
MAINTENANCE

Polaris RZR XP Turbo Specifications

General

Brand	Polaris
Model	RZR XP Turbo
Category	Offroad Vehicle
Language	English