Chapter 10: Path Failover
Configuring Host Access to Storage Networking Drives and Partitions
408 Quantum Scalar i6000 User’s Guide
6 Click Next to display the Select Group Access Hosts to Add dialog
box.
7 Select the box in the Select column to indicate which host or hosts
to add to the group, or select the Select All Hosts box to add all of
the hosts in the group.
8 Click Finish to save the modification.
9 Click OK in the The Group Access was updated successfully dialog
box.
Removing a Host from an Access Group
Caution: Deleting a host from an access group will remove all host
mappings configured for the host.
To remove a host from a host access group:
1 Display the Host Access Group Configuration Wizard by
performing
Step 1 through Step 5 of Viewing All Access Groups on
page 417.
To Next Page
Loading...
