RFL Electronics IMUX 2000 - Page 765

Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL TMX/TMR RFL Electronics Inc.
January 25, 2012 3 (973) 334-3100
TMR SPECIFICATIONS
As of the date this Instruction Data Sheet was published, the following specifications apply to all RFL
TMR Telemetry Receiver modules. Because all of RFL products undergo constant improvement and
refinement, these specifications are subject to change without notice.
Analog Output: -50mA to +50mA
Output Compliance: -10V to +10V
Main Communications: Unidirectional DS0
Auxiliary Communications: Proprietary Serial Control Bus (SCB)
Accuracy:
@+25
o
C: +/- 0.05 percent of Full Scale.
Drift: 0.003 percent/
o
C over operating temperature range. Six-month
drift for identical input value and identical temperature is 0.01
percent maximum.
Resolution: 16 Bits
Frequency Response: 100 Hz Max @ 95% accuracy
Environmental Requirements:
Operating Temperature: Full performance (+32
o
F to +131
o
F)
Humidity: 0 to 90 percent, non-condensing.
MTBF (Calculated): Bellcore TR-332 > 500,000 Hours at 25
o
C
RFI/EMI: C.37.90.2, IEC-801-X
Live Insertion/Extraction: Capable of live insertion and extraction into the IMUX 2000
chassis without interruption to the DS1 or any other DS0.
Input Power Requirements (Typical):
+5-Volt Input: +4.75 to +5.25 volts @ 40 ma
+15-Volt Input: +14.75 to +15.25 volts @ 75 ma
-15-Volt Input: -14.75 to -15.25 volts @ 80 ma
Interface: MA-700 Module Adapter.
Dimensions:
Width: 14 mm (0.55 inches)
Height: 114 mm (4.5 inches)
Depth: 248 mm (9.76 inches)