Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
IMUX 2000 VVS RFL Electronics Inc.
October 4, 2000 (973) 334-3100
4
DS64NC SETUP
The DS64NC provides the point to point communications circuit for the VS100 Module. The VS100 will
operate with any bandwidth from 64 kb/s to 2.048 mb/s. The setup of the DS64NC is covered in detail in
its data sheet. The MA412 must be set for an external clock (TT) for use with a VS-100.
Figure 3. System block diagram
NOTICE
The information in this publication is proprietary and confidential to RFL Electronics Inc. No part of this
publication may be reproduced or transmitted, in any form or by any means (electronic, mechanical, photocopy,
recording, or otherwise), or stored in any retrieval system of any nature, unless written permission is given by RFL
Electronics Inc.
This publication has been compiled and checked for accuracy. The information in this publication does not
constitute a warranty of performance. RFL Electronics Inc. reserves the right to revise this publication and make
changes to its contents from time to time. We assume no liability for losses incurred as a result of out-of-date or
incorrect information contained in this publication.
MA-800 VS-100 CODEC
MA-412 DS-
64NC
CM3C
MA-800 VS-100 CODEC
MA-412
DS-
64NC
CM3C
Publication No. ID IMUX 2000 VVS
Printed in U.S.A.
October 4, 2000
RFL Electronics Inc.
353 Powerville Road
Boonton Township, NJ 07005-9151
Phone: (973) 334-3100
Fax:
973
334-3863
To Next Page
Loading...