Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
IMUX 2000 VVS RFL Electronics Inc.
October 4, 2000 (973) 334-3100
3
SPECIFICATIONS
Configuration One video channel per card
Video Input NTSC Composite / PAL Composite
Frame rate 1-20 fps dependent on bandwidth
Bandwidth required 64-2048 kb/s
Resolution 352x288
Compression Algorithm ITU H.261
Power Consumption 1.75A @5V
Chassis Space required 3 IMUX module slots
Video Interface 1 BNC Connector
External Power Option 5V +/- 5% pluggable terminal block
Temperature & Humidity -20
o
C to +55
o
C, 0-95% relative humidity, non-condensing
EXTERNAL POWER REQUIREMENTS
The Codec and therefore the VS100 draws a lot of current from the +5V. Users must ensure that at least
1.75 A is available in the IMUX chassis for each VS100. External +5V connections are available on the
MA800 for systems where the draw exceeds the power supply capability.
SYSTEM DIAGRAM
Figure 2. Hardware configuration, top view.
IMUX MOTHERBOARD
DS64NC MA-412
VS100 MA-800
CODEC
TO
CAMERA OR
VIDEO MONITOR
To Next Page
Loading...