Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
DISPLAYING PROGRAMMING HELP
To see a list of all programming commands, use the "H" command.
MA-490-P>H [ENTER]
When you invoke the "H" command, the programming menu shown in Figure 10 will re-appear on
your screen.
LEAVING THE PROGRAMMING MODE
NOTE
Before leaving the Programming Mode, use the “SV” command or your changes
will be lost.
Whenever you are finished programming the MA-490, use the "Q" command:
MA-490-P>Q [ENTER]
The "Q" command tells the MA-490 to leave the programming mode and return to the normal "MA-
490>" prompt. If you changed any setting while in the programming mode, be sure to use the "SV"
command described above to save the changes before invoking the "Q" command; otherwise, your
changes will be lost.
SAVING NEW PROGRAMMING SETTINGS
The "SV" command saves any new settings you made while in the programming mode:
MA-490-P>SV [ENTER]
The "SV" command tells the MA-490 to store all the changes in its non-volatile memory. Once the
changes are stored, the "MA-490-P>" prompt will reappear.
Before you enter the "SV" command, the MA-490 operates according to the old parameter settings.
Once the "SV" command is entered, the new settings will be in effect.
The new parameter settings can be verified by re-issuing the "D" command to display the parameter
settings list. (For more information on the "D" command, go to page 20.)
RFL MA-490 Telnet I/O RFL Electronics Inc.
March 6, 2007 19 (973)
334-3100
To Next Page
Loading...