Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
THE PROGRAMMING MODE
You can use APRIL and your PC or laptop to program the MA-490. To use your PC or laptop to
program the MA-490, use the "P" command.
MA-490>P [ENTER]
The "P" command tells the MA-490 to send a list of all programming commands to your PC or laptop.
The "P" command is password-protected.
If the proper password is entered, a programming menu similar to the one shown below will appear.
H - Display programming help
Q - Leave programming menu
SV - Save new settings
C - Change password (superuser authorization required)
D - Display present settings and parameter numbers
## - Edit this specific number parameter
MA-490-P>
Figure 13. Typical programming menu
You are now in the programming mode, as indicated by the "MA-490-P>" prompt on your screen. You
may now use the programming commands to re-program the MA-490. For more information on each
programming command, refer to the paragraph numbers listed below.
Command Meaning Page
H Display programming help 17
Q Leave programming menu 17
SV Save new settings 17
C Change password 20
D Display current settings and parameter numbers 18
## Edit the parameter number “##” 18
RFL MA-490 Telnet I/O RFL Electronics Inc.
March 6, 2007 18 (973)
334-3100
To Next Page
Loading...