Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Chapter 9 - SNMP Configuration and Control
SNMP Access Gateway User’s Manual - v1.0 -- 11/99 - Page 35
pagerDialDelay This integer is the number of seconds that the
SNMP Access Gateway waits for modem carrier after
dialing the pagerPhonenumber when the pager is in
alphanumeric mode, or the number of seconds the
SNMP Access Gateway waits after dialing the
pagerPhonenumber to transmit the pagerID when in
numeric mode.
pagerHangupDelay This integer is the number of seconds the SNMP
Access Gateway waits before hanging up the modem
after transmitting the pagerID or pagerMessage
when in numeric pager mode.
pagerMessage This text object is a text message transmitted to
an alphanumeric pager by the SNMP Access Gateway,
or a second pager message which is transmitted by
the SNMP Access Gateway when in numeric mode.
pagerSendId When this integer object is set to 0, the SNMP
Access Gateway does not transmit the unitId to the
alphanumeric pager, and when set to 1 the SNMP
Access Gateway does transmit the unitId to the
alphanumeric pager when performing an alphanumeric
page
pagerSendReason When this integer object is set to 0, the SNMP
Access Gateway does not transmit the reason for
the pager to the alphanumeric pager, and when set
to 1 the SNMP Access Gateway does transmit the
reason for the page to the alphanumeric pager when
performing an alphanumeric page.
pagerMaxAttempts This integer is the maximum number of pager
attempts which are allowed before the pager action
is automatically retried. If set to 0, then the
pager action is never automatically retried.
pagerAttempts This integer is the number of pager attempts which
have been made for this pager.
pagerAttemptDelay This integer holds the number of minutes which
must expire before the pager action will again be
attempted.
pagerRepeat This object controls if a successful page is
repeated at some time interval, to ensure that the
alarm is serviced. When set to 0, no pager
repeats are performed for this pager. When set to
1, pager repeats are performed for this pager.
These repeats only are done on a successful pager
action.
pagerRepeatDelay This integer controls the number of minutes which
must pass after a successful page before the page
is repeated, when pager repeat mode is active.
9.9 - actionsTraps The actionsTraps section of the MIB controls
enterprise-specific traps sent by the SNMP Access
Gateway, and the format of these traps.
trapDateTime When the trapDateTime object is set to 0, then the
date and time of the activation of the alarm which
caused the trap to be issued are not included in
the trap alarm string. When the trapDateTime
object is set to 1, then the date and time of the
activation of the alarm which caused the trap to
be issued are included in the trap alarm string.
trapAlarmType When the trapAlarmType object is set to 0, then
the type of alarm (sensor, data alarm) which
caused the trap to be issued is not included in
the trap alarm string. When the trapAlarmType
object is set to 1, then the type of alarm which
caused the trap to be issued is included in the
trap alarm string.
To Next Page
Loading...