SERVICE PROGRAM MODE
SM 5-15 B121 Series/B259 Series
Service
Tables
Line Width Correction
4927*
Adjusts the line width correction algorithm. Positive settings produce thicker lines;
negative settings produce thinner lines. This setting is only applied to the originals
in SP4-921 ( 6.5.4).
4927 1 Line Width Correction (Copy) [–2 ~ 2 / 0 / 1/step]
Independent Dot Erase
4928*
Selects the dot erase level. Higher settings provide greater erasure. This setting is
only applied to the originals in SP4-921 ( 6.5.4).
4928 1 Independent Dot Erase (Copy) [–2 ~ 2 / 0 / 1/step]
Positive/Negative [0 = No, 1 = Yes]
4929*
Inverts white and black. This setting is only applied to the originals in SP4-921 (
6.5.4).
4929 1 Positive/Negative (Copy)
Sharpness-Edge [–2 ~ 2 / 0 / 1/step]
4930*
Adjust the clarity. This setting is only applied to the originals in SP4-921 ( 6.5.4).
4930 1 Sharpness-Edge (Copy)
Sharpness-Solid [–2 ~ 2 / 0 / 1/step]
4931*
Adjust the clarity. This setting is only applied to the originals in SP4-921 ( 6.5.4).
4931 1 Sharpness-Solid (Copy)
Sharpness-Low ID [–2 ~ 2 / 0 / 1/step]
4932*
Adjust the clarity. This setting is only applied to the originals in SP4-921 ( 6.5.4).
4932 1 Sharpness- Low ID (Copy)
4941*
White Line Erase [0 ~ 2 / 1 / 1/step]
4941 1 Selects the white line erase level ( 6.5.4).
0: None 1: Weak 2: Strong
• This setting is effective only Photo 1, Photo 3, Special 3 or Special 4 mode.
• 0: White line erase is not used, and white level correction is used instead·
• This setting is applied regardless of what mode has been selected in SP4-921.
4942*
Black Line Erase [0 ~ 3 / 2 / 1/step]
4942 1 Selects the black line erase level. This setting is effective only when originals are
scanned by the A(R)DF ( 6.5.4).
[0 = No / 1 = Very weak / 2 = Weak / 3 = Strong]
This setting is applied regardless of what mode has been selected in SP4-921.
To Next Page
Loading...
