SERVICE PROGRAM MODE
B121 Series/B259 Series 5-16 SM
SP5-XXX (Mode)
5001
All Indicators On
5001 1 All LEDs turn on. The LCD turns on or off every 3 seconds. Press the reset key to
end this program.
5104*
A3/DLT Double Count [0 = Enabled / 1 = Disabled /
2 = Disabled if the size is undetected]
5104 1 Selects whether the machine counts twice for each sheet of A3/11"x 17". If this is
set to “Yes” is selected, the total (mechanical) counter and the current user counter
will both increment by two for each A3/11" x 17" sheet.
5113*
Optional Counter Type 0: None
11: MF key card (Increment)
12: MF key card (Decrement)
NOTE: If 12 is selected duplex is not possible.
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120*
Clr-OP Count Remv [0=Yes / 1=Standby only / 2=No]
5120 1 Determines under which conditions the copy job settings are reset when the key
counter is removed. With 0, the settings are cleared if the counter is removed at the
end of a job or midway through a job. With 1, they are only cleared if the counter is
removed at the end of a job. With 2, they are not cleared at all, under either
condition. With duplex copies, the job settings are always preserved, regardless of
the setting of this SP mode.
5121*
Count Up Timing [0 = Feed In / 1 = Exit]
5121 1 Selects whether the key counter increments at time of paper feed-in or at time of
paper exit.
5127*
APS Mode [0 = Enabled / 1 = Disabled]
5127 1 Enables or disables the APS mode..
5501*
PM Alarm Interval (Printout) [0 ~ 9999 / 0 / 0K copies/step]
5501 1 Specifies when the PM alarm occurs.
5801
Memory Clear
5801 2 Engine 5.1.7
5802
Machine Free Run
5802 1 Starts a free run of both the scanner and the printer. Press "ON" to start; press
"OFF" to stop.
⇒
Rev. 6/2005
To Next Page
Loading...
