SERVICE PROGRAM MODE
SM 5-47 B121 Series/B259 Series
Service
Tables
5840* IEEE 802.11b
SSID Enter ID 5840 4*
Enters a unique ID (up to 32 characters long) to identify the device when it is
operating in an area with another wireless LAN network.
Channel MAX JA [1~14/ 14 / 1]
NA [1~11 / 11 / 1
EU [1~13 / 13 / 1]
China, Taiwan (Same as NA)
5840 6*
Sets the maximum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location. The
default settings are set for the maximum end of the range for each area. Adjust the
upper 4 bits to set the maximum number of channels.
Displayed only when the option 802.11b for wireless LAN is installed.
Channel MIN JA [1~14 / 1 / 1]
NA [1~11 / 1 / 1
EU [1~13 / 1 / 1]
China, Taiwan (Same as NA)
5840 7*
Sets the minimum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location. The
default settings are set for the minimum end of the range for each area. Adjust the
lower 4 bits to set the minimum number of channels.
Displayed only when the option 802.11b for wireless LAN is installed.
00: Key #1 0000 0000
01: Key #2 (Reserved) 0000 0001
10: Key #3 (Reserved) 0000 0010
WEP Key Select
11: Key #4 (Reserved) 0000 0011
5840 11*
Selects the WEP key. [00~11 / 00 / 1 binary]
WEP Mode 0: Max. 64-bit (10 characters)
1: Max. 128-bit (10, 26 characters)
5840 20*
Determines the operation mode of the WEP key.
Displayed only when the option 801.11b for wireless LAN is installed.
5842
Net File Analysis
5842 1* Specifies the output mode for debugging of each net file process. The 8th bit is
reserved. The 7th bit is the switch of debugging output for each module.
5843
Operation Panel Image Exposure [0: Off (disable) / 1: On (enable)]
5843 1* Enables and disables the operation panel read (dump) feature. After powering on
the machine, set this option to 1 to enable this feature. To reset the machine to 0,
the machine must be turned off and on again. Selecting 0 for this option without
cycling the power off and on does not restore the default setting (0).
To Next Page
Loading...
