FIRMWARE UPDATE PROCEDURE FOR MFP MACHINES
B121 Series/B259 Series 5-94 SM
10. Press the OK key.
• “Verify”, “UpDate” and “Exit”
will be displayed at the bottom
of the LCD, and the firmware
to be updated will be
highlighted (dark
background).
Note: Do NOT press the “Verify” key.
12. Remove the SD card from
the lower slot on the
controller by pushing on the
card to release the spring
lock.
13. Turn the main power switch
off.
14. Repeat Steps 7-13 above until
all firmware updates are
complete.
15. Reinstall the network and
Fax connections.
• If an error occurs, the error
code is displayed. For
information on the error codes,
see the table on next page.
• To quit the firmware-update program, press the F3 key.
Note: As mentioned above, it is possible to confirm which firmware version is
presently installed in the machine by accessing SP7-801-255. Print the
firmware list with SP5-990-005, and compare to the previous list to verify
changes.
• See section 5.2.4 Firmware Error Table (pg. 5-95) for details on any update
failures that occur during the procedure.
• If the “Please Wait…” display does not change over to “Program Update Menu
P.01,” it is possible the firmware has not been saved to the card correctly (e.g.
files saved to the wrong folder). Please refer to 5.2.2 SD card preparation to
verify if the firmware was saved to the card correctly.
Rev. 09/2004
Program UpDate Menu P.01
ROM: B1234567A
NEW: B1234567B
Exit UpdateVerify
11. Press the “UpDate” key.
• The update will begin, which
will take a few minutes to
complete. The LCD will
initially display, “Updating…
***---------“. When the update
is completed, the LCD display
will change to “Update done”
or “Updated / Power Off On”.
Program UpDate Menu P.02
“Updating…
***
_____
”
.
Exit
To Next Page
Loading...
