BIT SWITCHES
SM 27 B620
Fax Option
B620
System Switch 15 SP No. 1-101-022
No FUNCTION COMMENTS
0 Not used Do not change the setting.
1
Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
2-3 Not used Do not change the settings.
4-5
Wait time for post message
00: 1 minute
01: 30 minutes
10: 1 hour
11: 24 hours
The machine stays in the standby mode for the
specified time if it reserves a post message in
memory.
6
Shows user codes on reports
and lists
0: Disabled
1: Enabled
The user codes are printed on reports and lists. The
default setting is "Disabled" since the user codes
used for authentication should not be seen.
7 Not used Do not change the settings.
System Switch 16 - Not used (Do not change the settings.)
System Switch 17 - Not used (Do not change the settings.)
System Switch 18 - Not used (Do not change the settings.)
System Switch 19 SP No. 1-101-026
No FUNCTION COMMENTS
0-2 Not used Do not change the settings.
3
Selects a temporary address
for the number PC-FAX #.
0: When prefixed by #, handled only as a stored
address.
1: When prefixed by #, when a digit exists that
prevents handling the transaction as a Quick,
Speed, or Group dialing, handles temporarily.
4
Number of jobs controlled for
PC-FAX TX
0: 64 Jobs
1: No limitations (but
conforms to device
limitations)
Sets the number of jobs controlled for PC-FAX
transactions. If “1” is selected (no limitations), control
is relinquished to the device (standard 400,
expandable to 800).
5-6 Not used Do not change the settings.
7
Special original mode
0: Disabled
1: Enabled
Enables the user to select the special original mode
from the operation panel. When the user selects this
mode, the text-mode LED and the photo-mode LED
light at the same time.
To Next Page
Loading...
