Rockwell Automation Publication 193-UM015D-EN-P - February 2015 395
EtherNet/IP Communications Chapter 9
5. If the upload is successful, a display will appear indicating the success of
this command. Press OK to continue.
If the upload is not successful due to communication errors, a display will appear
indicating that the profile will use default settings. Press OK to continue, and
press Cancel to abort the Module Discovery process. Repeat steps 1-5.
ATTENTION: If an Upload command is not successful during Module Discovery,
failure to Cancel the Module Discovery process will result in the loss of any
preconfigured E300 Electronic Overload Relay configuration data. This
configuration data will not be retained and default values will be used when
adding an E300 Electronic Overload Relay online to a ControlLogix project.
To Next Page
Loading...
