R.10.44
SEL-421 Relay Reference Manual Date Code 20111215
Settings
Report Settings
Report Settings
Table 10.84 Analog Display Points
a
a
Analog Quantity Name, “User Text and Formatting”, “Text Size.”
Label Prompt
Default
Value
b
b
The SEL-421 has no default values programmed for these settings.
[Analog
Quantity Name]
Name of any element in element store None
[User Text] String of ASCII characters
except double quotation marks and {}
c
c
Total length of Analog Display Point is 20 characters.
None
[Formatting] {total width.characters to right of decimal place,
scaling factor}
d
d
See Display Points on page U.5.10 for examples of setting Analog Display Points.
None
[User Text] String of ASCII characters
except double quotation marks and {}
c
None
[Text Size] S for single, D for double S
Table 10.85 Local Control and Aliases
a
a
Local Bit, Local Name, Local Set State, Local Clear State, Pulse Enable.
Label Prompt Default Value
[Local Bit
number]
Valid Local Bit number (LB01, for example) None
[Alias Name] String up to 20 printable ASCII characters except
double quotation marks
None
[Alias
for Set State]
String up to 20 printable ASCII characters except
double quotation marks
None
[Alias for
Clear State]
String up to 20 printable ASCII characters except
double quotation marks
None
[Pulse Enable] Pulse Local Bit (Y, N) N
Tabl e 1 0 .86 Lo c al B it S E L
OGIC
a
a
Settings in Ta bl e 1 0. 8 6 appear if the associated local bit is defined. If no local bits are defined,
the whole category is hidden.
Label Prompt Default Value
LB_SPmm Local Bit Supervision (SELOGIC Equation, NA) 1
LB_DPmm Local Bit Status Display (SELOGIC Equation, NA) LBmm
Table 10.87 Report Settings Categories
Settings Reference
SER Chatter Criteria Table 10.88
SER Points and Aliases Table 10.89
Event Reporting Table 10.90
Event Reporting Digital Elements Table 10.91
NOTE: See corresponding command
descriptions SET R on page R.9.43
and SHO R on page R.9.47 to set or
show the Report settings.
To Next Page
Loading...
