Sel SEL-421 - Port Settings; Event Reporting Digital Elements; Port Settings Categories; Protocol Selection

R.10.46
SEL-421 Relay Reference Manual Date Code 20111215
Settings
Port Settings
Port Settings
Make Table 10.94 settings if preceding setting PROTO  RTD.
Table 10.91 Event Reporting Digital Elements
a
a
800 Relay Word bits maximum from 100 Rows maximum.
Label Prompt Default Value
[Relay
Word Bit]
Name of any Relay Word bit, or OFF Relay Word bits
b
b
See ACSELERATOR QuickSet Report > Event Report Digitals in the Relay Editor Settings tree view.
The rows containing the following elements are always included as part of the 100 rows:
TLED_1, TLED_2, TLED_3, TLED_4, TLED_5, TLED_6, TLED_7, TLED_8, TLED_9, TLED_10,
TLED_11, TLED_12, TLED_13, TLED_14, TLED_15, TLED_16, SPOA, SPOB, SPOC, FSA, FSB, FSC,
M1P, M2P, M3P, M4P, M5P, 67Q1, 67Q2, 67Q3, 67Q4, 51S1, 51S2, 51S3, Z1G, Z2G, Z3G, Z4G,
Z5G, 67G1, 67G2, 67G3, 67G4, RMBnA, TMBnA, RMBnB, TMBnB, ROKA, RBADA, CBADA,
LBOKA, ROKB, RBADB, CBADB, LBOKB, TRIP TP1, TP2, 52CL1, 52CL2, BK1CL, BK2CL
(n = 1–8,  = A,B,C). For row descriptions see Appendix A: Relay Word Bits.
Table 10.92 Port Settings Categories
Settings Reference
Protocol Selection See Table 10.93.
Communications Settings See Table 10.94.
SEL Protocol Settings See Table 10.95.
DNP3 Protocol (Serial) Settings See Table 10.96.
M
IRRORED BITS Protocol Settings See Table 10.97.
RTD Protocol Settings See Table 10.98.
Ethernet Settings See Ethernet Network Operation Settings on
page R.4.5.
FTP Settings See FTP on page R.4.7.
Telnet Settings See Telnet on page R.4.9.
IEC 61850 Settings See Section 8: IEC 61850 Communications in
the Reference Manual.
PMU Protocol Settings See Table 10.99.
Table 10.93 Protocol Selection
Label Prompt Default Value
EPORT
a
a
Not available in SEL-421 or SEL-421-1.
Enable Port (Y, N) Y
MAXACC
a
Maximum Access Level (1, B, P, A, 0, 2, C) C
PROTO Protocol (SEL, DNP, MBA, MBB, RTD, PMU) SEL
Table 10.94 Communications Settings (Sheet 1 of 2)
Label Prompt Default Value
MBT
a
Using Pulsar 9600 modem? (Y, N) N
SPEED
b
Data Speed (300, 600, 1200, 2400, 4800, 9600, 19200,
38400, 57600, SYNC
c
)
9600
DATABIT
d
Data Bits (7, 8 bits) 8
NOTE: See corresponding command
descriptions SET P on page R.9.43
and SHO P on page R.9.47 to set or
show the Port settings.