R.4.16
SEL-421 Relay Reference Manual Date Code 20111215
Communications Interfaces
Communications Card
GOOSE command is executed during CID file processing:
#>GOO <Enter>
CID file is currently being parsed. No GOOSE statistics available.
#>
SEL-421 is disabled (after CID file parsed successfully):
#>GOO <Enter>
Host Disabled. All GOOSE processing disabled.
#>
The GOOSE command supports only one optional parameter, cnt. The cnt
parameter causes the GOOSE command to be repeated cnt times. The valid
range of cnt is from 1–65535; and the default value of cnt is 1.
HELP
Because only a limited set of commands may be available at your current
access level, you may want to display a list of available commands. Use the
HELP command to display a list of available commands for your current
access level. The HELP command format and options are shown in
Tab le 4.14.
ID
It may be necessary to identify the firmware version of your Ethernet card for
diagnostic purposes or to verify that it is compatible with the firmware version
of your host. Use the ID command to identify the firmware version and
several other internal parameters for your Ethernet card. The information
displayed by the ID command is described in Tab le 4. 15.
Table 4.14 HELP Command Options
Command Description
HELP Display command information for the current access level.
HELP command Display information for a specific command.
Table 4.15 ID Command Internal Parameters Displayed
Parameter Description
FID Firmware ID
BFID SEL
BOOT Firmware ID
CID Firmware Checksum
DEVID Device ID
PARTNO Part Number
CONFIG Configuration ID
To Next Page
Loading...
