Siemens SINAMICS G120 - Page 102

Adapting the terminal strip
6.4 Analog inputs
Inverter with CU230P-2 Control Units
102 Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
Skip frequency band
Interferences in the cable can corrupt
small signals of a few millivolts. To be
able to enter a setpoint of exactly 0 V
via an analog input, you must specify
a
skip frequency band.
Skip frequency band of the analog input
p0764[0]
Skip frequency band of the analog input AI 0 (factory setting: 0)
p0764[1]
Skip frequency band of the analog input AI 1 (factory setting: 0)