Siemens SINAMICS G120 - Saving Settings on an Operator Panel

Backing up data and series commissioning
9.3 Saving settings on an operator panel
Inverter with CU230P-2 Control Units
332 Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
9.3
Saving settings on an operator panel
Precondition
When the power supply is switched
on, you can transfer
the settings of the inverter to the BOP
-2 or, vice versa,
transfer the data from the BOP
-2 to the inverter.
Inverter → BOP-2
Procedure
To back up the settings, proceed as follows:
Start data transfer in the menu "EXTRAS"
- "TO BOP".
You have backed up the settings.
BOP-2 → inverter
Procedure
To transfer the settings, proceed as follows:
1.
Start data transfer in the menu "EXTRAS" - "FROM BOP".
2.
Switch off the inverter power supply.
3.
Wait until all LED on the inverter go dark. Now switch on the
inverter power supply again. Your settings only become effective
after this power-on reset.
You have transferred the settings.