Siemens SINAMICS G120 - General Data, PM230 - IP20

Technical data
12.2 Technical data, Power Modules
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
377
12.2.1.1
General data, PM230 - IP20
Feature
Version
Line voltage
380 V ... 480 V 3-ph. AC ± 10%
Output voltage
0 V 3-ph. AC … input voltage x 0.95 (max.)
Input frequency
50 Hz … 60 Hz, ±3 Hz
Output frequency
0 … 650 Hz, depending on the control mode
Power factor λ
0.9
Line impedance
Uk ≤ 1%, no line reactor permitted
Starting current
Less than the input current
Pulse frequency (factory
setting)
4 kHz
The pulse frequency can be increased in 2 kHz steps up to 16 kHz (up to 8 kHz for 55 kW
and 75 kW). An increase in the pulse frequency results in a lower output current.
Electromagnetic
compatibility
Devices with filters in compliance with EN 61800-3: 2004 are suitable for Category C2
environments. For details, see the Hardware Installation Manual, Appendix A2.
Braking methods
DC braking
Degree of protection IP20 built-in units
PT devices
IP20 when mounted in a control cabinet
IP54 on the control cabinet wall
Operating temperature LO without power reduction:
HO without power reduction:
LO/HO with power reduction:
0 °C … +40 °C
0 °C … +50 °C
to 60 °C
For details, see the Hardware
Installation Manual.
Storage temperature
-40 °C … +70 °C
Relative humidity
< 95% - condensation not permissible
Contamination
Protected according to pollution degree 2 to EN 61800-5-1: 2007
Environmental requirements Protected against damaging chemical substances according to environmental class 3C2 to
EN 60721-3-3; 1995
Shock and vibration
• Long-term storage in the transport packaging according to Class 1M2 to EN 60721-3-1:
1997
• Transport in the transport packaging according to Class 2M3 to EN 60721-3-2: 1997
• Vibration during operation according to Class 3M2 to EN 60721-3-3: 1995
Installation altitude without power reduction:
with power reduction:
up to 1000 m above sea level
up to 4000 m above sea level
For details, see the Hardware
Installation Manual
Permissible short-circuit
current
Frame size D ... F: 65 kA
1)
Overvoltage category Supply circuits:
Non-supply circuits:
Overvoltage category III
Overvoltage category II
Standards UL
1),2)
, CE, C-tick
The drive only satisfies the UL requirements when UL-certified fuses are used.
1)
If fuse-protected with a listed Class J or 3NE1 fuse, rated voltage 600 VAC with the rated current of the specific
converter.
2)
UL available soon for frame sizes D … F