Configuring the fieldbus
7.1 Communication via PROFINET
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
111
Proceed as follows to set a specific telegram in the inverter:
Using STARTER or an operator panel, set parameter p0922 to the appropriate value.
You have set a specific telegram in the inverter.
Activating diagnostics via the control
The converter provides the functionality to transmit fault and alarm messages (diagnostic
messages) to the higher-level control according to the PROFIdrive error classes.
The functionality must be selected in the higher-level control (see example of STEP 7
(Page 437)) and activated by powering up.
To Next Page
Loading...
