Siemens SINAMICS G120 - Activate Diagnostic Messages Via STEP 7

Appendix
A.7 Application examples
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
437
A.7.2.4
Activate diagnostic messages via STEP 7
Procedure
Proceed as follows to activate the diagnostic messages of the inverter:
1. In HW Config, select the inverter.
Figure A-10 Highlight inverter in HW Config
2. By double clicking on slot 0 in the station window, open the property window for the
inverter's network settings.
3. Select the Parameters tab.
4. Activate the standard alarms.
You have activated the diagnosis messages.
With the next ramp-up of the controller, the diagnostic messages of the inverter are then
transferred to the controller.