Siemens SINAMICS G120 - Communication Via Ethernet;Ip; Connect Converter to Ethernet;Ip

Configuring the fieldbus
7.5 Communication via EtherNet/IP
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
137
7.5
Communication via EtherNet/IP
Via EtherNet/IP you can enter commands and setpoints, read-out status information and
actual values, change parameter values and reset faults.
Process data (setpoints, actual values, etc.) are transferred in EtherNet/IP using assemblies.
In addition to the assemblies, there are objects that you can use to set the communication.
The objects and assemblies supported by the inverter are described in Section Supported
objects (Page 140)
7.5.1
Connect converter to Ethernet/IP
The Control Units have two RJ45 sockets for connection to the control system, which you
can use to implement a line topology. You can implement all topologies by using switches.
We recommend the following connector with order number: 6GK1901-1BB10-2Ax0 for
connecting an Ethernet cable.
Instructions for assembling the SIMATIC NET Industrial Ethernet FastConnect RF45 Plug
180 can be found on the Internet under product information " "Assembly instructions for
SIMATIC NET Industrial Ethernet FastConnect RJ45 Plug
(http://support.automation.siemens.com/WW/view/en/37217116/133300
)".
Procedure
To connect the inverter to a control system via Ethernet, proceed as follows:
1. Connect the inverter to the control system via an Ethernet cable.
2. Either
create a generic I/O module (Page 147) in your control system for cyclic data exchange
between the control system and the inverter
or
load the EDS file of the ODVA into the control system. You can find the file in the internet
at:
(
http://www.odva.org/Home/CIPPRODUCTCOMPLIANCE/DeclarationsofConformity/Ethe
rNetIPDOCs/tabid/159/lng/en-US/Default.aspx).
You have connected the inverter to the control system via EtherNet/IP.
See also Section: Interfaces, connectors, switches, control terminals and LEDs on the CU
(Page 60).
Routing and shielding the Ethernet cable
Information can be found on the Internet: EtherNet/IP guidelines
(
http://www.odva.org/Home/ODVATECHNOLOGIES/EtherNetIP/EtherNetIPLibrary/tabid/76/l
ng/en-US/Default.aspx).