Siemens SINAMICS G120 - Changing Indexed Parameters; Directly Entering the Parameter Number and Value

Appendix
A.4 Handling the BOP 2 operator panel
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
419
A.4.2
Changing indexed parameters
Changing indexed parameters
For indexed parameters, several parameter values are assigned to a parameter number.
Each of the parameter values has its own index.
Procedure
To change an indexed parameter, proceed as follows:
1.
Select the parameter number.
2.
Press the OK button and set the parameter index.
3.
Press the OK button and set the parameter value for
the selected index.
You have now changed an indexed parameter.
A.4.3
Directly entering the parameter number and value
Directly select the parameter number
The BOP-2 offers the possibility of setting the parameter number digit by digit.
Prerequisite
The parameter number is flashing in the BOP-2 display.
Procedure
To select the parameter number directly, proceed as follows:
1.
Press the OK button for longer than five seconds.
2.
Change the parameter number digit-by-digit.
If you press the OK button then the BOP-2 jumps to the
next digit.
3.
If you have entered all of the digits of the parameter
number, press the OK button.
You have now entered the parameter number directly.