Siemens SINAMICS G120 - Digital Inputs

Adapting the terminal strip
6.2 Digital inputs
Inverter with CU230P-2 Control Units
94 Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
6.2
Digital inputs
Changing the function of a digital input
Interconnect the status parameter of the digital input with a
binector input of your choice.
Binector inputs are marked with "BI" in the parameter list of
the List Manual.
The adjacent figure shows the terminals of the digital input
s.
Table 6- 1 Binector inputs (BI) of the inverter (selection)
BI
Significance
BI
Significance
p0810
Command data set selection CDS bit 0
p1036
Motorized potentiometer, setpoint, lower
p0840
ON/OFF1
p1055
Jog bit 0
p0844
OFF2
p1056
Jog bit 1
p0848 OFF3 p1113 Setpoint inversion
p0852
Enable operation
p1201
Flying restart enable signal source
p0855
Unconditionally release holding brake
p2103
1. Acknowledge faults
p0856
Enable speed controller
p2106
External fault 1
p0858
Unconditionally close holding brake
p2112
External alarm 1
p1020
Fixed speed setpoint selection bit 0
p2200
Technology controller enable
p1021 Fixed speed setpoint selection bit 1 p3330 Two/three-wire control, control
command 1
p1022 Fixed speed setpoint selection bit 2 p3331 Two/three-wire control, control
command 2
p1023 Fixed speed setpoint selection bit 3 p3332 Two/three-wire control, control
command 3
p1035
Motorized potentiometer, setpoint, raise
A complete list of the binector outputs is provided in the List Manual.