Siemens SINAMICS G120 Original Instructions

Backing up data and series commissioning
9.4 Other ways to back up settings
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
333
9.4
Other ways to back up settings
In addition to the default setting, the inverter has an internal memory for backing up three
other settings.
On the memory card, you can back up 99 other settings in addition to the default setting.
You will find additional information on the Internet at: Memory options
(http://support.automation.siemens.com/WW/view/en/43512514
).
Table 9- 1 Operation on the BOP-2
Description
The converter writes its setting 0, 10, 11 or 12 to the memory
card in accordance with p0802. The file on the memory card is
assigned the number according to p0802.
The converter loads the setting with the number according to
p0802 from the memory card and thus overwrites its setting 0,
10, 11 or 12.

Siemens SINAMICS G120 Specifications

General

Power Range	0.37 kW to 250 kW
Output Voltage	0 V to Input Voltage
Frequency Range	0 Hz to 650 Hz
Enclosure Rating	IP20, IP21, IP55
Control Modes	V/f control, vector control, servo control
Protection Features	Overvoltage, undervoltage, short circuit
Communication Interfaces	PROFIBUS, PROFINET, Modbus RTU
Operating Temperature	-10°C to +50°C
Cooling Method	Air cooling
Input Voltage	200 V to 240 V, 380 V to 480 V, 500 V to 690 V