Setting functions
8.4 Setpoint calculation
Inverter with CU230P-2 Control Units
246 Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
The maximum speed limits the speed
setpoint range for both directions of
rotation.
The inverter generates a message
(fault or alarm) when the maximum
speed is exceeded.
If you must limit the speed depending on the direction of rotation, then you can define speed
limits for each direction.
Table 8- 18 Parameters for minimum and maximum speed
Maximum speed (factory setting: 1500 rpm)
Speed limit, positive direction of rotation (factory setting: 210,000 rpm)
Speed limit, negative direction of rotation (factory setting: -210,000 rpm)
To Next Page
Loading...
