Siemens SINAMICS G120 - Connect the Converter to PROFINET

Configuring the fieldbus
7.1 Communication via PROFINET
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
109
7.1.2
Connect the converter to PROFINET
Connecting up
Connect the inverter (IO device) and your PG/PC (IO supervisor) via PROFINET cables with
the control. The maximum permissible cable length is 100 m.
See also Section: Interfaces, connectors, switches, control terminals, LEDs on the CU
(Page 60).
Figure 7-1 Example: PROFINET in a line topology
Recommended PROFINET connectors and pin assignment
We recommend the following connector with order number: 6GK1901-1BB10-2Ax0 for
connecting the PROFINET cable.
Instructions for assembling the SIMATIC NET Industrial Ethernet FastConnect RF45 Plug
180 can be found on the Internet under product information " "Assembly instructions for
SIMATIC NET Industrial Ethernet FastConnect RJ45 Plug
(http://support.automation.siemens.com/WW/view/en/37217116/133300
)".
Laying and shielding the PROFINET cable
Information can be found on the Internet: PROFIBUS user organization installation
guidelines (http://www.profibus.com/downloads/installation-guide/
).