Siemens SINAMICS G120 - Safely Remove the Memory Card

Backing up data and series commissioning
9.1 Backing up and transferring settings using a memory card
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
329
1.
Remove the USB cable if one is inserted in the inverter.
2.
Attach the BOP-2 operator panel to the inverter.
3.
Go to the menu level "EXTRAS".
4.
Start data transfer in the menu "EXTRAS"
- "FROM CRD".
5.
Switch off the inverter power supply.
6.
Wait until all LED on the inverter go dark.
7.
Switch on the inverter power supply again.
Your settings take effect after this power-on reset.
You have written the settings from the memory card to the inverter.
9.1.3
Safely remove the memory card
NOTICE
Destruction of files on the memory card when the memory card is removed
If you remove the memory card when the converter is switched on without implementing the
"safe removal" function you may destroy the file system on the memory card. The memory
card will then no longer function.
Only remove the memory card using the "safe removal" function.