08/2005 Commissioning HMI Advanced (IM4)
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
IM4/2-87
30=CondWait.bmp ;Waiting for safe operation
31=CondWait.bmp ;No channel ready
32=CondStop.bmp ;Oscillation active
33=CondWait.bmp ;Axis replacement active (block change inhibited
because axis replacement in progress)
34=CondWait.bmp ;Axis container rotation
35=CondWait.bmp ;AXCT: following axis active
36=CondWait.bmp ;AXCT: leading axis active
37=CondWait.bmp ;AXCT: follow up mode active
38=CondWait.bmp ;AXCT: internal status change
39=CondWait.bmp ;AXCT: Axis/spindle disable
40=CondWait.bmp ;AXCT: Corr. motion active
;Axis container replacement: Superimposed motion
41=CondWait.bmp ;AXCT: Axis replacement active
42=CondWait.bmp ;AXCT axis interpolator active
43=CondWait.bmp ;Waiting for compile cycle
44=CondWait.bmp ;Access to system variable
45=CondStop.bmp ;Search target found (;block search has found
search target and the NCK has stopped)
46=CondWait.bmp ;Rapid return started
47=CondWait.bmp ;AXCT: Waiting for spindle stop
;Axis container exchange
48=CondWait.bmp ;Machine data matching (;New config)
49=CondWait.bmp ;Axis replacement: axis in coupling
50=CondWait.bmp ;Axis replacement: Liftfast active
51=CondWait.bmp ;Axis replacement: New-Config active
52=CondWait.bmp ;Axis replacement: AXCTSW active
53=CondWait.bmp ;Axis replacement: Waitp active
54=CondWait.bmp ;Axis in another channel
55=CondWait.bmp ;Axis replacement: axis PLC axis
56=CondWait.bmp ;Axis replacement: axis reciprocating axis
57=CondWait.bmp ;Axis replacement: axis jog axis
58=CondWait.bmp ;Axis replacement: command axis
59=CondWait.bmp ;Axis replacement: axis OEM axis
60=CondWait.bmp ;coupled following axis
61=CondWait.bmp ;coupled following axis
62=CondWait.bmp ;coupled slave axis
63=CondWait.bmp ;HOLD at cycle end M0
64=CondWait.bmp ;HOLD at cycle end M1
65=CondWait.bmp ;Wait: Axis is at limit stop
[Pos1]
ChanStatFeedStopSpindleStop = 1 ;Channel status of channel 1 is displayed,
superimposed
Spindles = 1,2 ;by feed disable for channel 1 and spindle disable
;for spindles 1 and 2
[Pos3]
SpindStat = 1 ;Spindle status for spindle 1
;ChanStatFeedStop = 3 ;Channel status of channel 3 is displayed, superimposed
;with feed disable for channel 3
[Pos5]
ChanStat = 2 ;Channel status for channel 2 is displayed
;SpindStat = 3 ;Spindle status for spindle 3 is displayed
To Next Page
Loading...
Need help?
General
