Commissioning HMI Advanced (IM4) 08/2005
2 Functions/Parameterization
© Siemens AG, 2005. All rights reserved
IM4/2-88 SINUMERIK 840D sl/840D/840Di/810D Installation and Start-Up HMI (IAM) - 08/2005 Edition
[Pos9]
ChanStatFeedStopSpindleStop = 1 ;Channel status of channel 1 is displayed, superimposed
Spindles=1 ;by feed disable for channel 1 and spindle disable
;of Spindle 1
[Pos11]
ChanStatFeedStop = 2 ;Channel status of channel 2 is displayed, superimposed
;with feed disable for channel 2
[Pos13]
SpindStat = 2 ;Spindle status for spindle 2
[Pos15]
ChanStatFeedStopSpindleStop = 1 ;Channel status of channel 1 is displayed, superimposed
Spindles=1 ;by feed disable for channel 1 and spindle disable
;of Spindle 1
[UserIcons]
;UI_0 = <name.bmp> , <Position> ;Name of icon, position
...
;UI_31 = <name.bmp> , <Position> ;Name of icon, position
;USER_ICON_BASE = DBxx.DBByy
; Number of data block with the
; double word for user icons
; yy start byte of double word
[UserTextInfo]
;USER_TEXT_BASE = DBxx.DBByy
; xx data block with interface for
; user messages in the header
; yy start byte for interface
; TextLength=33 ; Activate text limit if
; user texts are used
[OemIcons]
;Oem_ICON_BASE=DBxx.DBByy
;OI_0= = <name.bmp> , <Position> ;Name of icon, position
...
;OI_31 = <name.bmp> , <Position> ;Name of icon, position
[OEMTextInfo]
;OEM_NUMBER_TEXTFIELD=3 ;A maximum of 3 text fields per line, i.e.,
; a total of 6 text fields in two lines is possible.
;Output length limited to a max. of 38 characters
;per line.
;OEM_TEXT_BASE=DBxx.DBByy
To Next Page
Loading...
Need help?
General
