08/2005 Expanding the Operator Interface (BE1)
3 Syntax
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D HMI Installation and Start-Up Guide (IAM) – 08/2005 Edition
BE1/3-91
Passivate Program (PP)
The PP (Passivate Program) function transfers a file from the active file system on
the NC to the passive file system on HMI Advanced. Once the PP function has
been executed, the file is no longer present in the active file system of the NC.
With HMI Embedded/HT6 this function has the same effect as Delete enable.
PP("file")
where:
File Complete path name of NC file to be transferred
PP("\MPF.DIR\MESSEN.MPF")
Select Program (SP)
The SP (Select Program) function selects a file in the active NC file system for
execution, i.e., the file must be loaded into the NC beforehand.
SP("file")
where:
File Complete path name of NC file
//M(TestGC/"Code generation:")
DEF VAR1 = (R//1)
DEF VAR2 = (R//2)
DEF D_NAME
LOAD
VAR1 = 123
VAR2 = -6
END_LOAD
OUTPUT(CODE1)
"Cycle123(" VAR1 "," VAR2 ")"
"M30"
END_OUTPUT
PRESS(VS1)
D_NAME = "C:\TMP\MESSEN.MPF"
GC("CODE1",D_NAME) ;Write code from OUTPUT method in
;Write file C:\TMP\MESSEN.MPF
END_PRESS
PRESS(HS8)
AP("\MPF.DIR\MESSEN.MPF") ;Load the file into the NC
SP("\MPF.DIR\MESSEN.MPF") ;Select file
END_PRESS
To Next Page
Loading...
Need help?
General
