118 Description Of Specific Functions
V560 Series High Performance Closed-Loop Vector Inverter User Manual
The inverter can run without running permission signal.
1: Permitted when the multifunctional terminal is effective (Function No. 43)
The inverter will not start until the multifunctional input terminal (Group F3.0) which is defined to be running
permissible (Function No.43) is effective; If it is void, the inverter will stop in the way defined by the kilometer
of this parameter, and will then automatically run again after signal recovery.
2: Command word from standard fieldbus (effective when standard expansion card is equipped)
The start permission signal is from the bus command word.
X _ _ _ : The action mode when the running permission signal is void
0: Free stop
The inverter stops outputting, and the motor stops freely.
1: Deceleration stop
The inverter will stop at deceleration mode according to preset deceleration time.
F0.4.38 Start/Stop Mode(H) Setting range: 0000~0101 Factory default: 0000
_ _ _ X : Start mode
0: Normal start
There are no special requirements for most load start mode. normal start mode will be adopted.
1: Revolution tracking start
It is applicable to the occasion of fault resetting and restart and restart after power-off. The inverter will
automatically judge the running speed and direction of the motor, and starts the rotating motor in a smooth
and impact-free way according to the detection and judge results; See below figure for the revolution tracking
start sketch.
Not clear
command
Re-giving
command
Auto
clear
command
Deceleration sto
Free sto
Motor status
Running command
Running permission
Start permission
Deceleration time
Acceleration time
Figure 7-15 Schematic diagram of start process
To Next Page
Loading...
Need help?
General
