Warning, Alarm Diagnosis And Counter Measures 207
V560 Series High Performance Closed-Loop Vector Inverter User Manual
8.5 RESET OF WARNING OR ALARM FAILURE
When warning or alarm failure appears, the following operations can be selected:
1. When failure code displays, press STOP/RESET key.
2. When external terminal operation command channel is adopted and the terminal for failure reset is
defined as valid in multifunctional input terminal Dix, the failures are reset.
3. When the field bus operation command channel is adopted, the upper computer can send fault reset
command to frequency inverter through RS485 interface.
4. Power off.
¾ The failures causes must be checked thoroughly and eliminated before reset, otherwise,
the frequency inverter may be damaged permanently.
¾ If it can not reset or failures reoccur after reset, it should check the causes; continuous
reset will damage the frequency inverter.
¾ The reset shall be conducted 5 minutes later in overload and overheating protection
action.
¾ When external terminals control, the fault reset shall be conducted after the removal of
terminal operation command.
To Next Page
Loading...
