SYSMEX CA-500 - Contents Stored in EEPROM; Items Needing Backup When Initializing

5.4.8 Contents stored in EEPROM
(1) Standard Curve data
Units for calculation parameters
(2) User settings
Auto Val/Out
Mark Limits
Replic. Limits
Report Limits
Set Test Name
Set Reagent Name
Test Protocol
Set Replication
Test Group
Reagent Holder
Alarm Settings
Conversation
Host Computer
Barcode Scanner
Date Format
Password
(3) Manufacturer settings
Service settings
Analysis Parameters
Confirmation Mode
Reagent Vial settings
(4) Others
Detector block sensitivity adjustment value
Temperature control value
Touch panel position adjustment calibration value (fixed)
XYZ Axes position adjustment value
Barcode DC motor position adjustment value (fixed)
Pressure adjustment
Main unit temperature Conversion value
Sensor temperature Conversion value
(5) Others
Barcode scanner types
Ensuring the dummy range
5.4.9 Items needing backup when initializing
The following items are required the backup (printing out) when replacing PCB No.6362.
(1) EEPROM
All data excluding fixed data.
(2) BBRAM
Group selection number
Rinsing time
CA-500 Series S/M 5-8 Revised December 2001 8