SYSMEX CA-500 - Barcode Mod. 7; Wash Test Mode; ADC BUFF (for Factory Use Only); Vlin Interim (for Factory Use Only)

5.7.3 Barcode Mod. 7
This setting is used for the use of bar code check digit “Modulus 7”.
ON: Used
OFF: Not used
5.7.4 Wash Test Mode
This setting is used to enter the rinse solution amount check mode.
ON: Enter the wash test mode (for production and servicing use only).
In the Wash Test Mode, the sample probe does not come down into the rinsing cup during
reagent dispense sequence.
OFF: Customer mode.
5.7.5 ADC BUFF (For Factory Use Only)
This setting is used for the factory use only.
ON: Used
OFF: Not used
5.7.6 Vlin interim (For Factory Use Only)
This setting is used for the factory use only.
ON: Used
OFF: Not used
CA-500 Series S/M 5-18 Revised December 2001 8