SYSMEX CA-500 - Page 98

CA-500 Series S/M 5-3 Revised July 2003 16
[Next Page]
Use this key to display the following parameters:
Parameter Description Key to be Used Selection
Chrom. Select whether to use Chromogenic Unit.
(1)
Next Option ON/OFF
Immuno. Select whether to use Immuno. Unit. (1) Next Option ON/OFF
Wavelength Select the wavelength of the aperture for
Immuno. Unit.
Next Optioin 575 nm or 800nm
DFbg (2) Next Option ON/OFF
APTT Warm (3) Numeric Keys 120 thru 300
D-Dimer Init. Select the parameter for D-Dimer. Next Option DD PLUS, Adv.DD
or LPIA DD
TTO (1) Next Option ON/OFF
NT (1) Next Option ON/OFF
TT (1) Next Option ON/OFF
PCc (1) Next Option ON/OFF
BXT (1) Next Option ON/OFF
LA1 (1) Next Option ON/OFF
LA2 (1) Next Option ON/OFF
APL (1) Next Option ON/OFF
Plg (1) Next Option ON/OFF
Hep (1) Next Option ON/OFF
SFDP (1) Next Option ON/OFF
PFDP (1) Next Option ON/OFF
Maintenance Rinse Select whether to use Maintenance
Rinse menu.
Next Option ON/OFF
Terralin Select number of times to fill up Terralin
when executing Maintenance Rinse.
Numeric Keys 1 thru 10
Water Select number of times to rinse when
executing Maintenance Rinse.
Numeric Keys 1 thru 10
+Fbg / -Fbg 16 Select whether to use +Fbg and -Fbg. Next Option ON/OFF
* (1), (2) and (3) indicated in the “Desctiption” of the table above correspond to (1), (2) and (3) indicated
at the beginning of this section. For parameters which are set to OFF for (1) are as below:
• No test protocols will be displayed in the test setting screen.
• No reagents will be displayed in the reagent name setting screen.
• The settings will not be initialized by using “Init. Settings-1” and “Init. Entire Memory” on the “Initial”
menu.