Terex Fuchs MHL380 D User Manual

4 DISPLAY AND CONTROL ELEMENTS
4.28 MHL380 D
ATTENTION
To prevent damage to the engine,
do not drive at full power just after
starting. Drive with restraint until the
machine reaches operating tem-
perature.
ATTENTION
After switching on the ignition, the speed is al-
ways set to the lower idle speed (0%). This
means that the diesel engine can only be started
in lower idle mode!
When starting at temperatures below -18°C, we
recommend equipping the machine with a
DEUTZ cold start auxiliary device.
4.6.2.2 Warm start
►
Set all gearshift levers to neutral.
►
Insert the ignition key into the ignition lock
(55/60) and turn it to position I. If the en-
gine is warm, the preheat indicator (55/75)
will only light up briefly. Wait for approx. 5
- 10 seconds for the machine control
unit to start, until the indicators (55/36),
(55/37), (55/49), and (55/50) appear on
the display.
►
When the indicators (55/36), (55/37),
(55/49), and (55/50) are displayed, turn the
ignition key through position II to position III
 Diesel engine starts.
►
As soon as the diesel engine is running, let
go of the ignition key. It will automatically
return to position I. The indicators for bat-
tery charge control (55/36) and for engine
oil pressure (55/37) should go out.

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English