Terex Fuchs MHL380 D User Manual

7 CARE AND MAINTENANCE
7.56 MHL380 D
7.9.5.1 Tensioning V-belts of generator
►
Switch off the diesel engine and remove
the ignition key.
►
Disconnect the power supply using the
battery isolator switch.
►
Loosen the screws (206/1) and fastening
screws (206/2), but do not screw them out
completely.
►
Loosen counter nut (206/3) of adjusting
bolt (206/4). Tighten adjusting bolt (206/4)
clockwise until the V-belt (206/5) has
reached the required belt tension.
►
Tighten screw (206/1) and fastening
screws (206/2), as well as counter nut
(206/3) of tensioning bolt.
►
Check the tension again.
►
Switch the battery isolator switch on.
Figure 206 Tensioning and replacing V-belts

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English