8 MALFUNCTION
8.2 MHL380 D
8.2 Diesel engine
All defects and faults in the diesel engine
must be inspected as described in the sepa-
rate Deutz operating instructions.
During the warranty period, malfunctions must
be dealt with by the responsible service agent
or a specialist workshop.
8.3 Lowering the loading equipment
when the engine has shut down
If the diesel engine has shut down, you can
lower the loading equipment by means of the
four-way control levers, assuming that the
necessary pilot pressure is available. The igni-
tion must be switched on.
h Chapter 5.1.1 ISO control system
The machine can be equipped with hose rup-
ture safety devices as an option which will
keep the loading equipment in position if a
hose or line breaks. Controlled lowering is
possible.
8.4 Emergency control
The machine is equipped with an emergency
control system. Please contact your dealer or
a TEREX | Fuchs service engineer for more
detailed information.
j
Danger of injury due to unex-
pected machine movements.
• You should only use emergency
control to move the machine out
of the danger zone.
• Move the machine with care and
be prepared for unexpected
movements.
• Inform all persons who operate or
maintain the machine about the
change in operation.
• Any damage to the machine
which requires the use of the
emergency control must be made
good immediately.
In an emergency: Administer first
aid, seek treatment from a doctor
To Next Page
Loading...
Need help?
General
