Terex Fuchs MHL380 D User Manual

SPECIAL EQUIPMENT 10
MHL380 D 10.3
10.1.2 Operation
In the outrigger menu F 2 (see Fig. 237), the
status indicator of the outrigger deselection
will be shown. In this menu, each of the four
outriggers can be deselected individually.
The status of the proximity switches is also
displayed with the following meanings
Green
:
Proximity switch is assigned
(sees metal) ou
trigger is be-
tween "Extended" limit po
si-
tion and "Deactivation po
si-
tion".
Orange
:
Proximity switch is not
as-
signed (does not see metal)
outrigger is in "Deactivation
position".
Red/orange
flashing
:
Proximity switch is not
as-
signed (does not see metal)
ou
trigger is in "Deactivation
position".
To bypass deactivation and therefore to re-
tract the outrigger to its top limit position,
move the control lever in the retract direction
and at the same time press and hold down
the multi-function button or F 2 key on the
display. After 3 seconds all outriggers are
automatically selected and then move to the
top limit position. To do this the control lever
should be moved further in the retract direc-
tion and/or F 2 must remain pressed!
As soon as the bypass is active (proximity
switch display flashes red/orange), the rotary
lock is automatically blocked. This block re-
mains in place until all four outriggers are
back in the proximity switch's "green zone",
i.e. until all four proximity switches are as-
signed again (see metal). The rotary drive
block remains in place even after ignition
OFF/ON!
MHL-NBXX-760
DESELECT OUTRIGGERS
Fig. 237 Outrigger menu

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English