Terex Fuchs MHL380 D User Manual

SAFETY AND ACCIDENT PREVENTION 2
MHL380 D 2.17
2.3.6 Repairs on the machine
 Do not attempt to lift heavy parts. Use work
aids designed for this purpose with sufficient
carrying capacity. Fasten and secure
individual parts and large assemblies
carefully on lifting equipment so they cannot
cause any danger. Use only suitable lifting
equipment which is in perfect working order.
Loads must be supported by hoisting
equipment with sufficient carrying capacity.
Do not stand or work under suspended
loads.
 Do not use lifting equipment that is damaged
or does not have sufficient carrying capacity.
Wear protective gloves when working with
wire cables.
 Only experienced persons must be assigned
the task of attaching loads and acting as
banksmen to guide crane drivers. Banksmen
must remain within the operator's range of
vision or stay in voice contact.
 For jobs above head height, use designated
climbing aids and work platforms that meet
safety requirements. Do not use machine
parts as climbing aids if they were not
designed for that purpose. Wear fall
protection for work performed at high
heights. Keep all grips, steps, platforms, and
ladders, etc. free of dirt, snow and ice.
 When working on equipment, ensure there is
adequate support. Avoid metal-to-metal
contact.
 Always support the machine so that any
shifting of weight will not endanger stability.
Avoid metal-to-metal contact.
 Work on drive mechanisms, brake and
steering systems must only be performed by
specialist personnel trained for the task in
question.
 If the machine needs to be repaired on an
incline, place blocks under the wheels to
secure them.
 Only persons with specialist knowledge and
experience are permitted to perform work on
hydraulic equipment.
 Wear protective gloves when searching for
leaks. A fine jet of pressurized liquid can
penetrate the skin.
 Do not loosen any lines or screw couplings
until the loading equipment has been set
down, the diesel engine has been turned off
and pressure has been released from the
hydraulic system. Once the diesel engine
has been turned off, place the ignition key in
the contact position and move all joysticks
and similar devices (four-way control levers
and pedals) in both directions to release the
control pressure and dynamic pressures in
the hydraulic circuits. Then reduce the
pressure inside the container as described in
these operating instructions.

Terex Fuchs MHL380 D Specifications

General

Brand	Terex
Model	Fuchs MHL380 D
Category	Construction Equipment
Language	English