EasyManuals Logo

Terex Fuchs MHL380 D User Manual

Terex Fuchs MHL380 D
332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #303 background imageLoading...
Page #303 background image
CARE AND MAINTENANCE 7
MHL380 D 7.81
7.11.2 During shutdown
Once the machine has been out of use for six
months, all assemblies must be brought to
operating temperature and set in motion for
approx. 15 minutes.
First, the layer of corrosion protection must be
cleaned off the piston rods of the hydraulic
cylinders, and the openings of the air filter
pipe and the exhaust pipe must be freed.
Once the machine has been set in motion, it
must be preserved again as described above.
7.11.3 After shutdown
Proceed as follows when putting the machine
back into operation:
â–º
Clean the layer of corrosion protection off
the piston rods of the hydraulic cylinders.
â–º
Free the air filter pipe and the exhaust gas
opening.
â–º
Check the condition of the air cleaner main
cartridge and safety cartridge and replace
if necessary.
â–º
Clean the machine with a neutral deter-
gent.
â–º
Check the batteries. If necessary, charge
and install them.
â–º
Follow the instructions in the diesel engine
operating instructions for putting the diesel
engine back into operation.
â–º
Lubricate the machine according to the
lubrication schedule.
7.11.4 Once the machine has been out of
use for more than half a year
â–º
Change the oil in assemblies such as the
transmission, etc.
â–º
Replace the hydraulic fluid filters (return
and ventilation filters).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Terex Fuchs MHL380 D and is the answer not in the manual?

Terex Fuchs MHL380 D Specifications

General IconGeneral
BrandTerex
ModelFuchs MHL380 D
CategoryConstruction Equipment
LanguageEnglish

Related product manuals